RGC3063 Montigo Proflame Remote Transmitter for IPI CPI Fireplaces

RGC3063 Montigo Proflame 2 Remote Control Transmitter GTMFL series for use with IFC Proflame systems using both the IPI and CPI fireplace features.

This Montigo Proflame 2 remote control transmitter for Sit Controls was used on many Montigo direct vent gas fireplaces and stoves and has the ability to control several fireplace control features.

You can program this remote to your existing fireplace or stove with a simple programming feature on your current IPI control module and the auto program feature in the Proflame 2 handheld remote control.

Push the SW1 program button one time on your IPI Control module and you should hear the 3 short beep telling you the receiver is now ready to accept a new code from the remote transmitter.

Now push the On/Off button of your handheld remote transmitter and you should hear 4 beeps from the IPI control module telling you the module and the remote are now paired with the same RF code and ready to be used.

If after you have performed this procedure you are still not able to control your gas log set remotely then the most common failure part is the IPI/CPI module.

Service Note:

It is recommended to use standard alkaline batteries in these transmitters. The use of lithium ion batteries has been found to throw an ER9 code due to higher voltage. If you have an ER9 code, transmitter battery measure error, appearing on your unit and you have lithium batteries installed, swap them out for standard alkaline batteries. If the code reappears, the remote will need to be replaced.