BISZY BLOWER CENTRAL AIR KIT BIS ULTRA SERIES

The BISZY is a Blower Central air Kit for the BISULTR series units from Lennox and IHP.

This blower kit is used with the forced air system which provides distribution of warm air to another room or to a central heating system.

Used on fireplace models:
Brentwood LV, Brentwood SP,
Ladera,
Villa Vistam,
Montecito, Montecito Estate,
WRT4820WS,WCT4820WS,WRT3820WS,WCT6820WS,WCT6840WS,WRT4826WH,
BIS Ultima CF, BIS Ultima-1, BIS Nova, BIS Panorama, BIS Tradition CE, and BIS Tradition

BISZY is rated for 250 CFM

Installation Instructions
Step 1. Locate the warm air outlet, make sure it respects the maximum distances, plan for the passage through walls, ceilings etc., when mapping out the path the duct will take.
Step 2. Locate the area where the flexible pipe will hook up to the appliance.
Step 3. Remove the corresponding 5-inch plate, cut the insulation following the hole diameter and screw in the flexible pipe adaptor
These plates are located in the following places:
On the Solana, HE43-2 and SE36 fireplaces, on the upper left and right hand sides of the unit.
On the Brentwood SP, BIS® Ultima-1, WCT4820WS, Brentwood LV, BIS Ultima CF, WRT4820WS, Montecito, BIS Tradition CE, WCT6820WS, Villa Vista, BIS Panorama, WRT4826WH, Montecito Estate, BIS Tradition, WCT6840WS, Ladera, BIS Nova, WRT3820WS, Cambria, Le Laval and BIS Ultra fireplaces, on the upper left and right hand sides as well as the back of the unit.
Step 5. Bring the flexible pipe to the desired room.
Step 6. To install the blower, place the four (4) anti-vibration rubbers in the holes of the support plate of the blower and screw the blower to a solid base. The blower may be installed either horizontallyor vertically but must be easily accessible for maintenance as well as for the electrical installation.
Step 7. With the second tightening collar, install the flexible pipe to the round central inlet of the blower

See manual for more details.