2025 © Allparts Equipment & Accessories. All Rights Reserved.
910-570 Regency Handheld Transmitter by Sit Controls GTM Series
In stock
Part Number
910-570
$103.87
Regency 910-570 Remote Handheld Transmitter is an auto programming model remote for the GTM Proflame Series remotes used by many different fireplace manufacturers.
This receiver allows the following fireplace accessories to be controlled.
Manual On Off Function
Room Thermostat Temperature Controlled On Off Function
Manual Modulating Flame Heights 6 Levels
Automatic Manual Modulating Flame Heights " Smart Sense"
This Regency Receiver was used on many of the fireplace and gas logs systems used by Regency and was manufactured by Sit Controls.
Before replacing your current transmitter make sure to inspect the contacts and springs inside of the Proflame transmitter and install new alkaline batteries.
See Service Information Tab:
We are sorry but REMOTE TRANSMITTERS and REMOTE RECEIVERS are "NOT RETURNABLE" for refunds!
These items comes with a 90 day warranty for exchange only.
Please look at all pictures carefully and study your manual before you purchase this item because no returns for refunds will be accepted.
Allparts offers free testing on most Remote Transmitters and Remote Receivers for customer who choose to send these items in for testing before purchasing any electronic products.
Write Your Own Review
Troubleshooting -
The first thing to check here before replacing either the receiver or the transmitter is going to be the battery connections in the receiver.
The receiver is exposed to much more heat and will typically be the item that is replaced most often due to the heat, but the connections still are the first thing to check.
Remove the receiver box from the fireplace. Carefully remove the battery door cover 0.584.806 and batteries from the receiver,
Be careful when servicing the receiver or changing the batteries not to break the tabs of the battery door cover.
Turn the cover over and remove the 2 small phillips screws in the back of the receiver.
Now slide the circuit board / battery contact housing out from inside of the receiver.
Inspect the circuit board for corrosion, if you find corrosion on the circuit board you may need to replace the receiver with the new 0.584.221 Remote Receiver.
Inspect the battery contacts and springs, clean the positive battery contacts and then stretch the negative battery contact springs in the battery contact housing.
Also clean the positive battery contacts on the battery door that was removed and also stretch the negative battery contact springs on the door.
Clean the receiver housing of any debris, dirt, dust or corrosion before reassembly.
Now reassemble the receiver in the reverse order of disassembly and install new Energizer alkaline batteries.
After installing the batteries you should hear 1 beep telling you the receiver has power and is ready to be programmed.
Push the program button one time and you should hear the 3 short beep telling you the receiver is now ready to accept a new code from the remote transmitter.
Now push the On/Off button of your remote transmitter and you should hear 4 beeps from the receiver telling you the receiver and the remote are now paired with the same RF code and ready to be used.
If after you have performed this procedure you are still not able to control your gas log set remotely then the most common failure part is the receiver.
N/A