113963-01 SPARK PLUG FLAME SENSOR REPLACEMENT KIT

In stock
Part Number
113963-01
$19.60
Part Number: 113963-01
Shipping Weight: 0.3125 Lbs

113963-01 Spark Plug flame sensor was used by Desa International on the several lines of portable construction heaters and has now be updated and replaced with the new style flame sensor electrode kit

The new Spark Plug Sensor Kit is the replacement part for the previous part number 113963-01 Spark Plug Flame sensor for Desa Heaters


Service Note:

The 113963-01 Spark Plug replacement kit instruction to convert to the new style sensor are as follows:


1.) Make sure the gas hose is not connected & the unit is unplugged from a power source before beginning the next steps.

2.)Take off bottom cover by removing the 4 support screws, carefully cut the zip tie at the wire bundle with the sleeve, the set of wires nearest the motor assembly/fan side of the unit (will not have the space to extract the motor until doing this step).

3.)Remove the 6 screws that mount the motor assembly into the unit. There are two at the top, two on the left & two on the right.

4.) Use a 13/16 socket or wrench with a long enough extension to reach inside the barrel of the heater from the motor end to loosen the nut on the spark plug. Once unloosened, the spark plug is to be removed from the unit along with the red ignitor wire that was connected to it. Remove this wire from the control board also, it will be replaced with the new wire in the retro-fit kit.

5.) Once the spark plug has been completely removed, place new ignitor into the same hole & use the self-tapping screw (#10 included in the kit) to mount it through the bracket hole & the heat shield as shown. (see picture in overview)

6.) Swap the red ignitor wire with the wire provided in the replacement kit. Plug the new wire into control board & route it through the same hole the original wire was routed through.

7.) Remount the motor/ bottom plate & replace the zip tie.

1) Make sure the gas hose is not connected and the unit is unplugged from a power source before beginning the next steps.

2) Take off bottom cover by removing the 4 support screws, carefully cut the zip tie at the wire bundle with the sleeve, the set of wires nearest the motor assembly/fan side of the unit (will not have the space to extract the motor until doing this step).

3) Remove the 6 screws that mount the motor assembly into the unit. There are two at the top, two on the left and two on the right.

4) Use a 13/16 socket or wrench with a long extension to reach inside the barrel of the heater from the motor end to loosen the nut on the spark plug. Once unloosened, the spark plug is to be removed from the unit along with the red ignitor wire that was connected to it. Remove this wire from the control board also, it will be replaced with the new wire in the retro-fit kit.

5) Once the spark plug has been completely removed, place new ignitor into the same hole and use the self-tapping screw (#10 included in the kit) to mount it through the bracket hole and the heat shield.

6) Swap the red ignitor wire with the wire provided in the replacement kit. Plug the new wire into control board and route it through the same hole the original wire was routed through.

7) Remount the motor/bottom plate and replace the zip tie.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
No
No