2025 © Allparts Equipment & Accessories. All Rights Reserved.
7115203 Idle Down Valve and Cable Replacement Kit with Bolts
In stock
Part Number
7115203
Special Price
$42.90
Regular Price
$53.63
The 7115203 Idle Down valve and cable replacement kit is the complete engine throttle cable with attached idle down valve and mounting bolts for the FNA Group brands of pressure washers using this type of automatic idle control.
This 7115203 is used with the 510032 and 51ALD23 Vertical Axial pumps with the Push Idle control system.
This automatic Idle Control system was used on the following models of pressure washers:
-DeWalt DXPW3224I
-DeWalt DXPW3324I
Take great care in the tightening of the Banjo Bolt on these kits.
A Torque Wrench and a Digital Tachometer will be required for proper installation.
Over-tightening of the mounting bolt will result in the bolt breaking.
CAUTION:
Proper installations of the Banjo Bolt are critical to ensure functionality.
Use a Torque Wrench and a Digital Tachometer to perform the installation accurately.
Over-tightening the Banjo Bolt will result in bolt failure.
Additional Instructions:
With a 5mm Allen hex socket, install the threaded Valve Cap from the pump housing and torque to 12 Ft-lbs / 144 In-lbs.
SPECIAL NOTE: Do not tighten the valve cap and the Banjo Bolt together, as doing so may cause the bolt to break.
Torque Specifications:
Banjo Bolt: 7–8 Ft-lbs / 88–96 In-lbs / 10–11 N-m
Valve Cap: 13 Ft-lbs / 159 In-lbs / 18 N-m
Cable Retention Bolt: 7.3 Ft-lbs / 87.6 In-lbs / 9.9 N-m
Engineering Note:
Our engineering department has tested these Banjo Bolts to 30% above the manufacturer's suggested rated torque specifications without sustaining breakage during installation.
It is critical to proper installation that a Torque Wrench is used to avoid damaging newly installed components.
Failure to follow specific enclosed instructions may lead to damage or failure of newly installed components.
Exercise caution and precision during the process.
See the Included Instructions or download from this listing as a PDF Document Here
Write Your Own Review
CAUTION:
Proper installations of the Banjo Bolt are critical to ensure functionality.
Use a Torque Wrench and a Digital Tachometer to perform the installation accurately.
Over-tightening the Banjo Bolt will result in bolt failure.
Additional Instructions:
With a 5mm Allen hex socket, install the threaded Valve Cap from the pump housing and torque to 12 Ft-lbs / 144 In-lbs.
SPECIAL NOTE: Do not tighten the valve cap and the Banjo Bolt together, as doing so may cause the bolt to break.
Torque Specifications:
Banjo Bolt: 7–8 Ft-lbs / 88–96 In-lbs / 10–11 N-m
Valve Cap: 13 Ft-lbs / 159 In-lbs / 18 N-m
Cable Retention Bolt: 7.3 Ft-lbs / 87.6 In-lbs / 9.9 N-m
Engineering Note:
Our engineering department has tested these Banjo Bolts to 30% above the manufacturer's suggested rated torque specifications without sustaining breakage during installation.
It is critical to proper installation that a Torque Wrench is used to avoid damaging newly installed components.
Failure to follow specific enclosed instructions may lead to damage or failure of newly installed components.
Exercise caution and precision during the process.
No